SUP-FMC400 Slurry Electromagnetic flow meter

The electromagnetic flowmeter is designed based on the Faraday electromagnetic induction principle and used to measure the instantaneous flow rate of conductive liquids in enclosed pipelines in flammable and explosive environments. During on-site monitoring and display, standard current signals, pulse signals, and RS485 digital signals can be output for recording, adjustment, and control, achieving automatic detection and control. It can be widely used in industries such as tap water, chemical industry, coal, environmental protection, light textile, metallurgy, papermaking, etc.

Characteristics

Accuracy: Measurement value±0.5%(Flow velocity 0.5m/s~5m/s)

Direct measured variables ：Flow velocity

Calculated measured variables ：Volume flow , mass flow

Velocity of flow：Typically Velocity of flow：0.5m/s~5m/s

Note：If there are differences in the selection of individual specifications, the label shall prevail, and high-voltage can be customized

Introduction

The electromagnetic flowmeter is designed based on the Faraday electromagnetic induction principle and are used to directly measure the flow rate of conductive liquids in closed pipelines. During on-site monitoring and display, standard current signals, pulse signals, and RS485 digital signals can be output for recording, adjustment, and control, achieving automatic detection and control. It can be widely used in industries such as tap water, chemical industry, coal, environmental protection, light textile, metallurgy, papermaking, etc.

Specification

Product	Electromagnetic flowmeter
Model	SUP-FMC400
Diameter nominal	DN10~DN1000
Nominal pressure	DN15 - DN250, PN ≤1.6MPa
Nominal pressure	DN300 - DN1000, PN ≤1.0MPa
Accuracy	Measurement value ±0.5%(Flow velocity 0.5m/s~5m/s)
Repetitiveness	0.16%
Liner material	CR,UR,PTFE(F4),FEP(F46),and PTFE(PTA)
Electrode material	316L Stainless Steel, Hastelloy C, Hastelloy B, Ti, Ta, Pt
Medium temperature	Polyurethane: -10…+60℃ ;PTFE/FEP: -10…+120℃;Chloroprene: -10…+70℃；PFA: -10…+120℃
Power supply	AC：85V~264V，50Hz~60Hz; DC：18V~28V
Communications	RS485,MODBUS-RTU
Ingress protection	IP65

Measuring principle

Mag meter works based on Faraday's law, when the liquid goes through the pipe at the flow rate of v with a diameter D, within which a magnetic flux density of B is created by an exciting coil, the following electromotive E is generated in proportion to flow speed v:

E=K×B×V×D

Where:
E－Induced electromotive force
K－Meter constant
B－Magnetic induction density
V－Average flow speed in cross-section of measuring tube
D－Inner diameter of measuring tube

flowmeter principle

Features
Reliable measurement, high accuracy, and good stability.
Integrated structure, no moving parts, easy to install, maintenance free.
RS485 communication interface - standard Modbus RTU protocol.
It is not affected by the direction of the fluid and can be accurately measured in both directions.
Adopting advanced low-frequency square wave excitation, zero point stability, strong anti-interference ability, and reliable operation.
The orientation of the header/display interface can be adjusted for easy reading.
Built in bilingual Chinese and English, allowing for free switching.
Suitable for measuring low conductivity media.
Suitable for slurry measurement.
Suitable for filling measurement.